Mustefa  Jibril, Roman  Jirma, Messay  Tadese, 
    Metal Cutting Tool Position Control using Static Output Feedback and Full State Feedback
Controllers,
    International Journal of System Signal Control and Engineering Application,
    Volume 14,Issue 1,
    2021,
    Pages 18-25,
    ISSN 1997-5422,
    ijssceapp.2021.18.25,
    (https://makhillpublications.co/view-article.php?doi=ijssceapp.2021.18.25)
    Abstract: In this study, a metal cutting machine position
control have been designed and simulated using
MATLAB/Simulink Toolbox successfully. The open loop
response of the system analysis shows that the system
needs performance improvement. Static output feedback
and full state feedback H<sub>2</sub> controllers have been used to
increase the performance of the system. Comparison of
the metal cutting machine position using static output
feedback and full state feedback H<sub>2</sub> controllers have been
done to track a set point position using step and sine wave
input signals and a promising results have been
analyzed.
    Keywords: Metal cutting machine;full state feedback H2 controllers;static output feedback